Software & Hardware Configs

General discussion of 3D printers

Software & Hardware Configs

Postby bobt » Mon Dec 31, 2012 10:53 pm

Is it possible to get you to post your configuration of hardware and software that you use for 3D printing? It would be nice to have a baseline of what really does work in this environment of 10,000 different types of machines and 25,000 different types of software used. I just have to get a bigger computer to map this to a working environment. I think that I will use one of my Raspberry Pi's for this. Just kidding. :lol:

Bob Teeter
"What Box"
Posts: 49
Joined: Mon May 16, 2011 5:11 pm


Postby bdring » Mon Dec 31, 2012 11:35 pm

I'll see what I can do when I return home. There are a lot of configurations to deal with. Repetier Firmware, Repetier Host and Slic3r all have configurations. I maintain about a two dozen Sllic3r configs for fill percentages, etc.
"If you didn't build it, you will never own it."
Site Admin
Posts: 2966
Joined: Sun Nov 22, 2009 7:33 pm
Location: Chicago, IL, USA

Return to 3D Printer General Discussion

Who is online

Users browsing this forum: No registered users and 2 guests