gyrogearloose wrote:Ornicus, If it works for you, that is great. In my last post I said that you can print PLA on the coating while it is still tacky to obviate the need for heating, meaning you turn the short period in which the paint stays tacky to your advantage. Also, note that ordinary clear enamel spray is freely available everywhere and will cost you less than half of what you are using.
orcinus wrote:@SystemsGuy - this one: http://www.amazon.co.uk/Hellermann-Plas ... B000YIW7GS
Dries instantly and isn't tacky. Stuff sticks to it rather well when it's 40 degrees and above. You need to cool it to scrape the objects off, though, or you inevitably end up damaging the printed object.
Return to 3D Printer General Discussion
Users browsing this forum: No registered users and 13 guests