nismobg wrote:I just tried the 200x200 i have 300x 300 too , it took me exactly 11 min to reach 110C, I would guess my ramps 1.4 is the reason for not heating fast , I am not sure it can provide the amps needs to speed it it. Any solution on it ?
PS the MK2 heat bead takes 15 min to reach 110c on the same config
nismobg wrote:Well I use 62A 750W PSU and my temp gets to 110 in 11 min. Not to mention i have 4mm tempered glass on top and insulation on bottom.
Return to 3D Printer General Discussion
Users browsing this forum: No registered users and 9 guests