Setting z zero for a print.

General discussion of 3D printers

Setting z zero for a print.

Postby tmccafferty » Sun Mar 10, 2013 2:01 pm

Where do yo set the initial z zero for a print. Do you set it right at the glass and the software compensates for the first row or do you set it up off the glass a partial layer and it starts there?
tmccafferty
 
Posts: 131
Joined: Mon Jan 07, 2013 3:40 pm

Re: Setting z zero for a print.

Postby bdring » Sun Mar 10, 2013 2:36 pm

Most people use a piece of regular weight printer paper as a gauge. You want that to just start to have a little resistance at zero between the bed and the extruder tip.

If the tip is too high the first layer will not stick. You want that first layer to get a little flattened by thee nozzle. If the tip is too low it can be blocked by the bed and not flow.
Bart
"If you didn't build it, you will never own it."
bdring
Site Admin
 
Posts: 2966
Joined: Sun Nov 22, 2009 7:33 pm
Location: Chicago, IL, USA

Re: Setting z zero for a print.

Postby SystemsGuy » Mon Mar 11, 2013 12:14 am

Software - unless you specifically tell it to - does not compensate - zero is zero. I set mine using a feeler gauge, but a piece of paper is probably just as easy, and more often at hand. ;-)
SystemsGuy
 
Posts: 250
Joined: Sat Dec 29, 2012 7:44 am


Return to 3D Printer General Discussion

Who is online

Users browsing this forum: No registered users and 3 guests

cron