bdring wrote:The spectra cord drive system took a while to figure out. Once we had a plan, they only took about 15 minutes per axis, but the concept is probably going to eventually change.
bdring wrote:The build was actually a lot of fun. There were some very talented people who I could just hand of jobs to without worry, like "here solder up the motor drivers and set the current".
BenJackson wrote:Is that the setup that Tantillus uses? Some kind of thin line that just wraps around a shaft?
BenJackson wrote:Being surrounded by competent people is always awesome.
Return to 3D Printer General Discussion
Users browsing this forum: No registered users and 16 guests