Confused about fans

General discussion of 3D printers

Confused about fans

Postby tmccafferty » Tue Jun 11, 2013 4:20 am

I am a bit confused about fans in Marlin. In the configuration.h files, I found where you can enable a fan to come on when the steppers are active. In the pin.h file, if you have motherboard 33, it uses D9 for fan. If you setup motherboard 34 for dual extrusion, it sets pin 4 for fan and you need a buffer. In slic3r, you can set parameters for a fan that cools the printed material.

So, which pins are for which fan?
tmccafferty
 
Posts: 131
Joined: Mon Jan 07, 2013 3:40 pm

Return to 3D Printer General Discussion

Who is online

Users browsing this forum: No registered users and 1 guest

cron